Invite People

Share 4Engineers with your friends and help them get started!

Emails
Enter multiple email addresses by separating it with a comma.
Back

How Much Does Maintenance Factor Into Your Design Process?

 
I've seen plenty of equipment that was engineered beautifully but was an absolute nightmare to service.
A component that takes 10 minutes to replace on the bench can turn into a four-hour job once it's installed. Access, clearance, and serviceability don't always get the attention they deserve during the design phase.
In my experience, the best designs aren't just built to perform. They're built to be maintained. 

Login to comment

Login
Discussion

1 comment

Collapse this comment
chriskelvin 1 week ago
Agreed on the problem; a few things that actually move it at the design stage:

1. Reserve removal envelopes in the 3D model as solid objects, not notes. Exchanger bundle pull space (roughly the bundle length plus room for the extractor), motor and pump pull-out, and valve actuator removal heights. Piping designers route around solids; they route through notes.
2. Specify back pull-out pumps with spacer couplings where the service allows (standard for API 610 overhung types). The rotating element comes out without breaking suction/discharge piping or moving the driver, which also protects alignment.
3. Design for isolation, not just access. Every item you expect to remove needs a way to be isolated, drained, vented, and proven zero-energy. If that requires a unit shutdown, the 10-minute job is really a turnaround job.
4. Put a maintenance technician in the 30/60/90% model reviews with a list of expected replacements per item and their frequency. The high-frequency items get the best access; everything else can be harder to reach.

A useful test is to estimate MTTR including isolation and permitting, not just wrench time. That number is usually what exposes the bad layouts.
Report content
Reason Description